| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 2 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 3 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE.
|
| 4 |
|
LOCATE THE SOLENOID VALVE ON THE FRONT OF THE MACHINE.
|
| 5 |
|
PULL THE WIRE CONNECTORS ON THE TOP OF THE SOLENOID VALVE TO DISCONNECT THE WIRES.
|
| 6 |
|
REMOVE THE 2 BOLTS HOLDING THE SOLENOID VALVE TO THE FRAME.
| Wrench-Allen metric 4.0mm |
|
|
| 7 |
|
LOOSEN THE HOSE CLAMP SCREW TO REMOVE THE TOP FEEDER HOSE FROM THE SOLENOID VALVE.
| Screwdriver-flat tip |
|
|
| 8 |
|
REMOVE THE 2 HOSE CLAMPS TO REMOVE THE BRUSH FEEDER HOSES FROM THE SOLENOID VALVE. PULL THE SOLENOID VALVE FROM THE MACHINE.
| Screwdriver-flat tip |
|
|
| 9 |
|
REVERSE STEPS 3 THRU 8 TO INSTALL A NEW SOLENOID VALVE.
|